Metrohm IC Net 2.0 Bedienungsanleitung PDF herunterladen (Seite 90)

6 Devices

IC Net 2.0

Second column Program instruction (see below).

Third column Parameter for program instruction (see

below).

ENABLED Enable program start (a disabled program

is not started).

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

<Verify> Test the time program (error messages are

displayed if program is wrong).

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program page:

Instruction Parameter entry Meaning

Program RESET, END Set program flag. The END flag

can be used to end a program,

especially if the program time

should be longer than the chro-

matogram duration. Additional

steps after this flag are not al-

lowed. The RESET flag is used to

reset the parameters to the sys-

tem startup values.

Pump on, off Switch on or off the pump drive.

Links

The Links tab of the 754 Dialysis Unit is used for COM port selec-

tion and settings (details see section 5.2.4).

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 195 196

Keine Kommentare

Metrohm IC Net 2.0 Bedienungsanleitung Seite 90