Metrohm Thin-Layer cell Bedienungsanleitung PDF herunterladen (Seite 15)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

3 Installation

IC Equipment Thin-Layer cell

￭￭￭￭￭￭￭￭

Connect the cell output

Use a pressure screw (6.2744.014) to fasten a 1–1.5 m long piece of

the PEEK capillary (6.1831.010) to the Out connector on the measur-

ing cell.

Note

This capillary must be tested with the IC instrument the first time

the detector is put into operation, see Chapter "Start-up" in the

manual for the detector.

If the preheating capillary is not used, proceed as follows:

Connecting capillaries to the measuring cell

Connect the cell input

Use a pressure screw (6.2744.014) to fasten the detector input capil-

lary to the In connector on the measuring cell.